Belt machines for working glass

Belt machine 102 :

Fitted with a frequency variator, this new machine accepts silicon carbide abrasive belts as well as diamond-charged belts and polishing belts (cork or trizact). The speed is adjusted using a potentiometer.
Here it is presented with a table with castor rollers and accessories for automatically creating round shapes and chamfers.
Grinding the flat and the upper edges without turning the glass sheet.
For the lower edge, the volume must be turned upside down.

Belt machine 103 :

– Contact wheel, dia. 200 mm, 100 mm wide, coated with grooved rubber
– Cast iron top and bottom pulleys
– Nine-roller support bar
– Special sealed three-phase 2hp motor
– Sealed circuit-breaker
– High-protection polyurethane paint
– Abrasive belts, 3,350 x 100 mm
– Abrasive belt running speed 19 meters/second (mandatory cutting speed, necessary for best belt efficiency)
– Floor space: 0.80 x 0.65 m

Technical Data :

– Sheet metal casing, 8 mm thick
– Contact wheel diameter 200 mm, width 100 mm, coated in grooved rubber
– Upper and lower pulleys coated in polyurethane
– High-protection polyurethane paint
– Sealed motor : 1.5 KW
– Outline dimensions : 1.20×0.90×1.80 m
– Abrasive belt : 3350×100 mm
– Power supply : 220 V single-phase or 380 V three-phase
– Weight : approximately 200 kg (without accessories)

Belt speed :

Belt type Recommended speed
Alumina or cerium oxide : 10 m/s
Silicon carbide : 20 m/s
Polishing cork : 20 m/s
3M TRIZACT : 30 m/s
Diamond charged abrasive : 30 m/s

All our belt machines are available with standard or custom-dimensioned tables, as options.